電纜管模具生產材料選擇

電纜管模具的主要材質是使用4毫米面板，6*80筋板，底部需要使用槽鋼支撐，這樣才能滿足混凝土電纜管震動的需要。從電纜管鋼模具的名稱來看，也可以稱之為電纜管溝、電纜管道模具等。

The main material of the cable duct mold is 4mm panel, 6*80 rib plate, and the bottom needs to be supported by channel steel, so as to meet the needs of concrete cable duct vibration. From the name of steel mould for cable duct, it can also be called cable duct trench, cable duct mould, etc.

當前根電纜管模具系列的需要，長度都是4米結構的，采用大小頭對接模式，這樣能夠保證其緊密性。從混凝土電纜管的加工要求來說，全部都是預制加工，既可以保證其混凝土表面的光滑性，還能更好的滿足其要求。電纜管模具形狀和分析是一種特殊的模具，在模具生產中也更特殊，模具設計是為了滿足不同施工單位的要求，在模具生產中會有不同的規格，模具長度多為4米，模具寬度一般根據施工單位的要求定制，因此各種尺寸不固定，模具前后兩端設計有插座，施工對接方便。電纜管模具可以從名稱中知道，主要放置在地下鋪設電纜，模具整體結構相對簡單，模具兩側等類型的模具設計略有不同，將根據施工設計圖紙要求制作8+2.12+4，或其他形狀的模具，其他類型的模具加工略有不同，需要使用聚氯乙烯管連接模具孔，然后按步驟預制。

According to the requirements of the current root cable duct mold series, the length is 4m, and the large and small end butt joint mode is adopted to ensure its tightness. In terms of the processing requirements of concrete cable ducts, they are all prefabricated, which can not only ensure the smoothness of the concrete surface, but also better meet its requirements. The shape and analysis of the cable duct mold is a special mold, which is more special in the mold production. The mold design is to meet the requirements of different construction units. There will be different specifications in the mold production. The mold length is mostly 4 meters, and the mold width is generally customized according to the requirements of the construction unit. Therefore, various sizes are not fixed. Sockets are designed at the front and rear ends of the mold, which is convenient for construction and docking. As can be seen from the name of the cable pipe mold, it is mainly placed underground to lay cables. The overall structure of the mold is relatively simple. The design of the mold on both sides of the mold is slightly different. The mold of 8+2.12+4 or other shapes will be made according to the requirements of the construction design drawings. The processing of other types of molds is slightly different. PVC pipes need to be used to connect the mold holes, and then prefabricated according to the steps.