電力排管模具 高鐵電纜管模具澆筑方便 尺寸標準

電力排管模具模板電力排管模具，梁為橫向構件，其電力排管模板工程主要承受豎向荷載，如模板及支撐自重，鋼筋、新澆筑混凝土的自重，以及澆筑電力排管混凝土時的施工荷載等。因此要求模板的支撐數量足夠，搭設穩固。梁模板由底模及側模組成，底模承受豎向荷載，剛度較大，下設支撐；側模承受混凝土側向壓力。

The power pipe laying mold formworks are the power pipe laying mold. The beam is a transverse member. The power pipe laying mold works mainly bear vertical loads, such as the self weight of the formwork and support, the self weight of the reinforcement and the newly poured concrete, as well as the construction load when pouring the power pipe laying concrete. Therefore, the support quantity of formwork shall be sufficient and the erection shall be stable. The beam formwork is composed of bottom formwork and side formwork. The bottom formwork bears vertical load, has large rigidity, and is supported under it; The side formwork bears the lateral pressure of concrete.

埋線管模具是一種生產在各種電纜建設地區所保護電纜線路的混凝土制品的模具，為了能夠保證電纜在穿過管道時容易通過，摩擦系數能夠比較低，我們通常會建議各個預制廠先提前訂購一批直徑、長度規格同模具相同的塑料管，這樣在進行生產的時候，就能夠比較順利的讓電纜穿過，不會造成電纜線表面摩擦受損。

The buried pipe mold is a kind of mold for the production of concrete products for the cable lines protected in various cable construction areas. In order to ensure that the cable can pass through easily when passing through the pipe and the friction coefficient can be relatively low, we usually recommend that each prefabrication plant order a batch of plastic pipes with the same diameter and length specification as the mold in advance, so that the cable can pass through smoothly during production, It will not cause friction damage to the cable surface.